Penn Radiant Products
Penn Radiant Products
Mailing:
PO Box 1354
Wexford PA 15090
Shipping:
8105 Perry Highway
Pittsburgh PA 15237
Toll-Free Phone: 1-800-438-2503
Fax: 412-635-8016
customerservice@pennradiant.com
Print Back
Extend The Outdoor Heating Season
  • The new Space-Ray® Wind Blocker™. Tinted Ceramic Glass Series patio heaters are the perfect solution to extend the outdoor season by providing the warmth of radiant heat.
  • Provides a level of comfort for your outdoor dining and entertainment areas. Perfect for other partially covered outdoor environments like patios, bars and smoking areas.
  • Increases available outdoor restaurant seating capacity and revenue. For consumers it extends the outdoor season, permitting enjoyment of the outdoor space.
Unit of Measure

Specifications

Brands

 N/A Penn Radiant Products Space-Ray®

Control Options

 N/A Two Stage

High Input

 N/A 35000 Btu/hr

Low Input

 N/A 24000 Btu/hr

Horizontal Spacing Between Heaters

 N/A 8 to 16 ft

Angle Spacing Between Heaters

 N/A 6 to 14 ft

GAS Type

 N/A Propane

Burner Pressure

 N/A 11 inWc

Minimum Supply Pressure

 N/A 11.5 inWc

Maximum Supply Pressure

 N/A 14 inWc

Alternating Current (AC) Voltage

 N/A 120 V

Frequency

 N/A 60 Hz

Current

 N/A 0.1 A

Ignition Type

 N/A Direct Spark

Glass Material

 N/A Ceramic

Certification

 N/A Cloud Security Alliance (CSA)

Shipping Weight

 N/A 55 lb

Industry Standards

 N/A American National Standards Institute (ANSI) Z83.19 American National Standards Institute (ANSI) Z83.26

Typical Mounting Height

Horizontal Typical Mounting Height

 N/A 8 to 11 ft

Angle Typical Mounting Height

 N/A 7 to 9 ft

Note for Typical Mounting Height

 N/A The suggested mounting heights and spacing are subject to site conditions. Heaters can be operated at excessive weather conditions. Excessive weather and high winds (15+ mph) can reduce the effectiveness of the heaters.

Dimensions

Dimension A

 N/A 9-1/2 in

Dimension B

 N/A 11-1/2 in

Dimension C

 N/A 48 in

Optional WB Accessories

Optional WB Accessories

 N/A Item Name: Heat Shield
Item Description: Overhead Clearance Reduction. Through use of the optional Heat Shield, clearances above the heater can be reduced for applications with tighter overhead space.

Item Name: Wall Or Ceiling Mount
Item Description: Optional Mounting Bracket. The adjustable mounting brackets allows wall mounted or ceiling suspended heater installations at varying angles.

WB Control Options

WB Control Options

 N/A Item Name: Control Switch (L7)
Item Description: Individual Or Zone Control. Heaters can be controlled individually or in zones using 3-position switch or a thermostat. This permits low fire on mild days or full power on cold days.

Features

Features

 N/A In indoor and tightly sealed buildings this heater requires ventilation. An indirect vented installation requires a minimum ventilation flow of 4 CFM per 1000 BTU/hr of total installed heater capacity on natural gas by either gravity or power ventilation.

Venting Requirements - Indoor Installations

Venting Requirements - Indoor Installations

 N/A In indoor and tightly sealed buildings this heater requires ventilation. An indirect vented installation requires a minimum ventilation flow of 4 CFM per 1000 BTU/hr of total installed heater capacity on natural gas by either gravity or power ventilation.

Installation Requirements

Installation Requirements

 N/A Installation and service must be performed by a licensed contractor. The installation must conform to manufacturer's installation and operating instructions and local codes. In the absence of local codes, the installation must conform with the National Fuel Gas code, ANSI Z223.1 (also known as NFPA54) or GCA B149 installation codes.

For Your Safety

For Your Safety

 N/A Operate Wind Blocker™ infrared heaters with proper care and observe all safety precautions. Carefully follow printed installation, operating and cleaning instructions furnished with the heater. Do not store gasoline or combustible products in the vicinity of the heater. Keep children, clothes and drapery away from the heater. Do not touch the heater glass or the housing while the heater is in operation. Adequate ventilation must always be provided in accordance with national, state or local codes.

Additional Information

Additional Information

 N/A
  • Using the same principle as the sun, radiant warmth from Space-Ray®'s Wind Blocker™ Series is delivered directly to people at floor level first, before heating the surrounding air. This provides a comfortable envelope of warmth in seating areas below.
  • Designed with high temperature tinted glass which provides additional protection on windy days and enhances the heater's aesthetic appeal - unlike typical infrared patio heaters which are affected by the adverse effects of the wind and weather conditions, often resulting in flame lift-off - called heat rollout - and reduced efficiency in windy conditions.
  • Tinted ceramic glass provides cover for burner, protecting it from the wind and permitting consistent heat output.
  • No flame lift off (heat rollout).
  • Clearances above can be as low as 10" with optional shield.
  • Can be suspended from ceiling or angle mounted from column or sidewall with optional mounting brackets.
  • 3 mil hi-temp silicone powder coated paint for durability.
  • Covers 12' x 12' area with minimal wind conditions.
  • Factory shipped as a two stage control heater and can be used with optional 3 position switch for ultimate comfort. Operate at first stage (24,000 Btu/hr) during milder days and operated at full power (35,000 Btu/hr) on colder days.
  • Can be operated at full power (35,000 Btu/hr) as a single stage heater by a simple factory supplied jumper wire.

Note

Note

 N/A Can be operated as a single stage heater with factory supplied jumper wire.